Results 1 to 4 of 4
  1. #1

    mrtg setup and router question

    I am about to add a couple of people to my rack and had a few questions about setting MRTG. The first question is what is the best router to purchase between 250-500 that will allow access to the snmp port information? I have been looking at the linksys RV082.

    I assume you set mrtg to trace all the information going over a specific port? so that if there are 8 ip addresses going over one port all ips would be traced?

    How long should it take for someone with no MRTG knowledge to set this up for say 4-5 servers? On average per new server I add in the future how long should it take?

    thanks in advance

  2. #2

    Re: mrtg setup and router question

    Originally posted by rackcolo
    How long should it take for someone with no MRTG knowledge to set this up for say 4-5 servers? On average per new server I add in the future how long should it take?

    thanks in advance
    the most tricking part here is SNMP. Once you've figured SNMP, MRTG's cfgmaker will take few seconds to walk thru all SNMP links.

    regards,
    M.
    Powered by AMD & FreeBSD.
    "Documentation is like sex:
    when it is good, it is very, very good;
    and when it is bad, it is better than nothing."

  3. #3
    any thoughts on the router?

    linksys rv082

  4. #4
    should be good choice.

    regards,
    M.
    Powered by AMD & FreeBSD.
    "Documentation is like sex:
    when it is good, it is very, very good;
    and when it is bad, it is better than nothing."

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •